The JE-MA T35 "three in one" grain conveyor is
designed to transport grain either vertically or horizontally and fill
or empty horizontally and to fill or empty the store with the use of
only one drive station. The unit is assembled by using a series of
square tubes available in various lengths, which are connected together
by corner sections.
The grain is transported throughout the system by means of a heavy duty
roller chain with rubber flights, as used on the T20 and T60 elevators.
Any number of inlets and outlets can be fitted into any position along
the horizontal conveying section.
The motor is fitted onto a standard motor bracket which is fitted to
the return section. The drive is transmitted from the motor to the
conveyor by V-belts.
The inlet trough(s) on the lower conveyor introduces grain into the
system and can be supplied in varying lengths from 0.5m to 2.0m to suit
any installation.
Disc springs are fitted on the threaded spindles on the tightening
section to provide ample adjustment. These springs also provide a safety
factor by allowing foreign objects of a reasonable size fall through the
chain and sprocket without causing damage and then to the original
tension.
- Drive station
- Tightening section
- Corner section
- V-belt pulley drive
- conveying section
- inlet trough
- Return section
- Outlet
- Connecting conveying section/inlet through
Inside each inlet trough, a cover is provided to give an even feed
and to reduce any excess weight on the conveying chain by the incoming
grain.
When the T35 is employed for emptying a floor drying plant, the inlet
trough is placed in a trench in the ground. The trench is covered with
short timber or steel covers, which are made in such a way, that they
easily remove. To empty the plant these covers are gradually removed one
after another concurrently with the grain running into the inlet-trough.
In order to fill silos or floor drying plants the upper conveyor
length is fitted with outlets in any quantity needed.
The opening and closing mechanism of the outlets is controlled by remote
control i.e. a wire pull.
The outlet hoppers are fitted with a $k square flange, which will fit
any of our standard accessories.
| HP 1440 r.p.m. |
5.5 |
7.5 |
10.0 |
| Total length of chain |
up to 30 m |
30 - 50 m |
50 - 75 m |
|
